[GMCnet] Replacing rubber gas lines. Tanks to engine, and vents. [message #287671] |
Mon, 21 September 2015 07:56 |
BobDunahugh
Messages: 2465 Registered: October 2010 Location: Cedar Rapids, IA
Karma:
|
Senior Member |
|
|
When I last replaced all my rubber lines 11 years ago in the burned GMC. I bought a 25 ft roll. I think the hose was 3/8. And ended up using it all up. This afternoon I'm going to go get the donor GMC. I need some 3/8 rubber hose to run a line from a gas can, to an electric pump, then to the carb. As the gas in the tanks is 10 years old. So is most of the hose I'll need 3/8 ? I'm thinking that if I need 6 ft of 3/8 hose today. I might as will buy a roll now. I'm going to use the burned GMC frame, and drive train. That hose is all fine now. But as long as it's going to be all apart. It's a good time to replace it all now. The frame off restoration starts today.Thank Bob
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|