GMCforum: GMCnet » Onan question

Home » Public Forums » GMCnet » Onan question

Show: Today's Messages :: Polls :: Message Navigator

Onan question [message #285950]

Wed, 26 August 2015 20:00

jhbridges

Messages: 8412
Registered: May 2011
Location: Braselton ga

Karma:

Senior Member

Forthe Gugurs - Mr Miller comes to mind.

Dog show friend has an Onan 7KW Marquis. It failed AC output. Onan shop replaced the brushes and voltage regulator, it operated nmormally for a few uses ( 20 - 30 hours), then became very slow to come up to 120V at startup, but >if started under load< came up properly for a while, then up slowly, now no output. Any ideas as to what might be going on here? All input appreciated.

Maybe an out of round slipring? Loose bearing allowing the shaft to wobble?

--johnny

Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons. Braselton, Ga. I forgive them all, save those who hurt the dogs. They must answer to me in hell

Report message to a moderator

[Message index]

		Onan question By: jhbridges on Wed, 26 August 2015 20:00
		Re: Onan question By: Bullitthead on Thu, 27 August 2015 00:32
		Re: Onan question By: Bullitthead on Thu, 27 August 2015 00:38
		Re: Onan question By: stick miller on Thu, 27 August 2015 08:15
		Re: Onan question By: jhbridges on Thu, 27 August 2015 14:44
		Re: Onan question By: stick miller on Thu, 27 August 2015 17:50
		Re: Onan question By: jhbridges on Thu, 27 August 2015 19:10
		Re: [GMCnet] Onan question By: Jim Miller on Fri, 28 August 2015 16:12
		Re: Onan question By: jhbridges on Fri, 28 August 2015 18:51

Previous Topic:	Spring Washer on Powerlevel knob
Next Topic:	Dwayne Jacobsen

Goto Forum:

-=] Back to Top [=-

Current Time: Sat Sep 28 15:19:48 CDT 2024

Total time taken to generate the page: 0.00550 seconds