GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Frozen axle nut
Frozen axle nut [message #285601] Sat, 22 August 2015 15:04 Go to previous message
Francois is currently offline  Francois   United States
Messages: 161
Registered: October 2012
Location: Southern California
Karma:
Senior Member
Hi good fellows.

I have been taking things apart in preparation for an "out the top" engine swap. I took off the headers, intake manifold, water pump and fan, alternator,heads,fuel pump, distributor and power steering unit. Believe it or not those came off without incident. So, following the guide, I took off the right front wheel (front jacked up from the center with a 12 ton jack, 2 6 ton jack stands placed).

The axle nut won't budge. Have used 3/4 drive breaker bar with a pipe for leverage, an impact gun, various penetrating oils and propane heat.

I have an engine(a 403)all rebuilt with all the necessaries as I've read about, but if I can't get the right axle out....I can't remove the old engine.

I keep looking at it to see if it's reverse thread, but I don't think so.

Anyone have a suggestion?

I sure would be grateful
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Motorhome Marketplace Bobby Moore
Next Topic: More oil bybass paths??
Goto Forum:
  


Current Time: Tue Nov 19 00:04:01 CST 2024

Total time taken to generate the page: 0.02585 seconds