onan help needed 6000 model [message #282200] |
Wed, 15 July 2015 18:33 |
chasingsummer
Messages: 434 Registered: May 2011 Location: asheboro, nc
Karma:
|
Senior Member |
|
|
I am not reading 12 v going to starter when holding start button.
following the troubleshooting in manual, there is no fuel comming out of pump when turning over motor.pump output hose in my hand.
troubleshooting step 5b says jumper terminals 9 to terminal 11 and see if will start.
jumper wire gets very hot when i jump these 2 terminals. so hot i could not hold it, so I did not try starting when jumper was on. one of these has 12 volts to ground when sitting, other one does not. Cant remember for sure which one had the voltage, I think terminal 11.
Do i need a larger jumper wire?
level ground, oil level is at full per dip stick
Gas is being fed from small gas can, pick up hose is approx 16 inches long.
All input is appreciated,
thanks
bgk
brian
asheboro, nc
75 eleganza, 74 build
119k miles and counting,
DOG HOUSE
|
|
|