GMCforum: GMCnet » onan help needed 6000 model

Home » Public Forums » GMCnet » onan help needed 6000 model (want start. will turn over)

Show: Today's Messages :: Polls :: Message Navigator

onan help needed 6000 model [message #282200]

Wed, 15 July 2015 18:33

chasingsummer

Messages: 434
Registered: May 2011
Location: asheboro, nc

Karma:

Senior Member

I am not reading 12 v going to starter when holding start button.
following the troubleshooting in manual, there is no fuel comming out of pump when turning over motor.pump output hose in my hand.
troubleshooting step 5b says jumper terminals 9 to terminal 11 and see if will start.
jumper wire gets very hot when i jump these 2 terminals. so hot i could not hold it, so I did not try starting when jumper was on. one of these has 12 volts to ground when sitting, other one does not. Cant remember for sure which one had the voltage, I think terminal 11.
Do i need a larger jumper wire?
level ground, oil level is at full per dip stick
Gas is being fed from small gas can, pick up hose is approx 16 inches long.
All input is appreciated,
thanks
bgk

brian asheboro, nc 75 eleganza, 74 build 119k miles and counting, DOG HOUSE

Report message to a moderator

[Message index]

		onan help needed 6000 model By: chasingsummer on Wed, 15 July 2015 18:33
		Re: onan help needed 6000 model By: RF_Burns on Wed, 15 July 2015 19:44
		Re: onan update By: chasingsummer on Wed, 15 July 2015 19:44
		Re: [GMCnet] onan update By: Mr ERFisher on Thu, 16 July 2015 04:38
		Re: onan help needed 6000 model By: RF_Burns on Wed, 15 July 2015 20:20
		Re: onan help needed 6000 model By: JohnL455 on Wed, 15 July 2015 21:50

Previous Topic:	Zip Dee awning removal
Next Topic:	[GMCnet] Forum Private Messaging Turned OFF

Goto Forum:

-=] Back to Top [=-

Current Time: Tue Jul 02 21:27:12 CDT 2024

Total time taken to generate the page: 0.08675 seconds