455 crank [message #281222] |
Wed, 01 July 2015 18:37 |
roy1
Messages: 2126 Registered: July 2004 Location: Minden nevada
Karma:
|
Senior Member |
|
|
just a thought for those installing the 460 ford rear lip seal rather then the old rope seal. i was just setting my replacement crank in place and became aware the lip rides dead center on the serrated part of the crank this wasn't a problem on the old crank as the serration was well worn but this crank was not worn. i had purchased a genuine ford seal from summit but it would have leaked if i didn't notice. Mondello has a double lip seal that will work OK maybe Jim has one too. At any rate you need to use a double lip seal or have the serration milled off the crank if it isn't worn smooth.not a lover of oil leaks.
Roy Keen
Minden,NV
76 X Glenbrook
|
|
|