| Introduction and Alcoa Question [message #277601] |
Sun, 10 May 2015 17:38  |
 |
thainglo
Messages: 132
Registered: March 2015
Location: Iowa
Karma:
|
Senior Member |
|
|
Greetings! Been following the board for over a year and finally have a motorhome parked in the driveway. Its in very good shape, based on the dozen or so I looked at in the area. Going to start going thru it top to bottom, and wheels and tires are on the top of the list since the driver rearmost tire blew less than a mike from home. Was able to slowly limp it home, thankfully with minimal damage.
Going to be picking up an set of Alcoa wheels from a fellow is scrapping his coach, it is a bit of a drive so I want to make sure I've got all the tools needed. I have a 1 1/16" socket, but wondering what type of tool is needed to remove the lug but covers? I've seen Alcoa 000600 as a but cover wrench for hug-a-lugs, but think it might be for 33mm caps.
Anybody have the part number of the tool and good spo ts to buy?
Also, big thanks to Bob Dunahugh for all his help and guidance thru the process!
Matt Sladek
1976 Eleganza II
Coralville, IA
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
