GMCforum: GMCnet » Patching holes in Aluminum Sides

Home » Public Forums » GMCnet » Patching holes in Aluminum Sides

Show: Today's Messages :: Polls :: Message Navigator

Patching holes in Aluminum Sides [message #275042]

Sun, 05 April 2015 00:53

Broham

Messages: 204
Registered: March 2013
Location: Detroit, Michigan

Karma:

Senior Member

Hello all,

While was was replacing my headliner I found a few 1/8" or so holes from the old awning in the sides witch allowed water in. What is the best way (other that TIGing the holes up) to repair them with access to both sides? I'm thinking some tape on the outside and JB weld on the inside.

thanks in advance

Todd

Todd Owner of a 1976 Eleganza II 26’ other toys: 93 Vette 84 Goldwing and gone but not forgotten 72 CB750 Chopper 96 Caprice Classic 34 Ford roadster 94 Fleetwood

Report message to a moderator

[Message index]

		Patching holes in Aluminum Sides By: Broham on Sun, 05 April 2015 00:53
		Re: [GMCnet] Patching holes in Aluminum Sides By: USAussie on Sun, 05 April 2015 01:21
		Re: Patching holes in Aluminum Sides By: GeorgeRud on Sun, 05 April 2015 09:00
		Re: Patching holes in Aluminum Sides By: armandminnie on Sun, 05 April 2015 09:07
		Re: Patching holes in Aluminum Sides By: drdonaldg on Sun, 05 April 2015 10:52
		Re: Patching holes in Aluminum Sides By: Larry on Sun, 05 April 2015 18:53
		Re: [GMCnet] Patching holes in Aluminum Sides By: USAussie on Sun, 05 April 2015 19:41
		Re: [GMCnet] Patching holes in Aluminum Sides By: Mr ERFisher on Mon, 06 April 2015 09:17
		Re: Patching holes in Aluminum Sides By: Larry on Mon, 06 April 2015 16:46

Previous Topic:	Off-Topic: 2 bedrooms, but 16-car garage
Next Topic:	[GMCnet] Duracool sealant

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Nov 20 07:29:28 CST 2024

Total time taken to generate the page: 0.00831 seconds