[GMCnet] Carb rebuild [message #267918] |
Sat, 20 December 2014 09:38 |
Gerald Work
Messages: 102 Registered: June 2010
Karma:
|
Senior Member |
|
|
I do have direct experience with both Patterson and Bounds carbs, one on the Royale and one on the Clasco. I was asked a while back if they seemed different in any way, so I switched them and could detect no difference from the drivers seat or fuel consumption over the short test period. JimB's rebuilder sets them up on a flow bench just as DickP does and both clean to the same degree and appear to replace the same stuff inside. Can't comment on who uses which brand rebuild parts as I don't know. Bottom line from my direct experience from the drivers seat is it does not matter which you have. Both are good and both are likely better than anything you can do on your own without a flow bench.
Jerry
Jerry Work
The Dovetail Joint
Fine furniture designed & hand crafted
in the 1907 former Masonic Temple building
in historic Kerby, OR
http://jerrywork.com
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|