GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » oil cooler adapter gasket (how much should it be torqued?)
Re: oil cooler adapter gasket [message #260608 is a reply to message #260591] Mon, 01 September 2014 01:00 Go to previous messageGo to previous message
John Heslinga   Canada
Messages: 632
Registered: February 2011
Location: Edmonton, Alberta, Canada
Karma:
Senior Member
And one more picture of the Dorman 0_Ring in the Oil Cooler adaptor to show how it fits.

http://www.gmcmhphotos.com/photos/discussion-photos/p55769-silicone-o-ring-for-oil-cooler-adaptor.html
Note that the Square Key to clock the adaptor has been removed to allow me to Re-clock it to keep the oil cooler lines further away from my new headers.

Best Regards


John and Cathie Heslinga 1974 Canyonlands 260 455, Manny tranny and 1 ton, 3:70 LS, Red Seal Journeyman, DTE, BEd. MEd. Edmonton, Alberta

[Updated on: Mon, 01 September 2014 01:06]

Report message to a moderator

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Headliner
Next Topic: 1.25" pipe trolley?
Goto Forum:
  


Current Time: Mon Jun 24 06:52:30 CDT 2024

Total time taken to generate the page: 0.06125 seconds