[GMCnet] 12 volt power to bathroom lights [message #258047] |
Thu, 07 August 2014 10:18 |
Dave Motorhome
Messages: 175 Registered: July 2007
Karma:
|
Senior Member |
|
|
To help limit my destruction, I thought I would pose a question to the
group:
My bathroom lights are not working, I removed the lights and verified they
are working.. I tested the 12 volt cable.. no power.
So on that “circuit” the light above my table is the only one working.
I think… I need to get to the junction point where the lines from the fuse
panel split to the runs. I looked through the book 24-b has a sketch of the
lay out, but I could not find the junction box. I removed the ceiling in
the hall and loosened the ceiling in front of the fridge. But no junction
was found. Is the junction box above the bath unit? Above fridge?.. I would
hate to have to remove either to fix the lights.
--
David Paliotta
75 Glenbrook
Tulsa, OK
http://75glenbrook.googlepages.com/
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|