GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » 1-ton lower ball joint bolts
1-ton lower ball joint bolts [message #247518] Tue, 15 April 2014 16:20 Go to previous message
burtco99 is currently offline  burtco99   United States
Messages: 31
Registered: September 2007
Location: Montreal
Karma:
Member
Found this on Facebook.

http://www.gmcmhphotos.com/photos/front-suspension/p54330-1-ton-lower-balljoint-bolts.html

Not sure that the use of carriage bolts is very secure. Most carriage bolts I have used were equivalent to a grade 3 bolt. IMO a grade 5 or better bolt should be used for the balljoints.

The originator used the carriage bolts as a means of providing better CV boot clearance. He appears to be concerned about the CV boot getting torn up by the bolts supplied in the kit.



So, this brings up two questions for the benefit of everyone here:

1) Are carriage bolts strong enough to safely secure the lower balljoint?

2) Do the 1-ton set-ups have clearance issues between the CV boots and the balljoint bolts?




Les Burt
Montreal
1975 Eleganza 26ft
A work in Progress
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Hamilton Work Rally - 31 May
Next Topic: GMC and Ham Radio
Goto Forum:
  


Current Time: Fri Oct 04 10:20:10 CDT 2024

Total time taken to generate the page: 0.01374 seconds