GMCforum: GMCnet » [GMCnet] FW: Reminder Torsion Bar installation and other stuff.

Home » Public Forums » GMCnet » [GMCnet] FW: Reminder Torsion Bar installation and other stuff.

Show: Today's Messages :: Polls :: Message Navigator

[GMCnet] FW: Reminder Torsion Bar installation and other stuff. [message #247304]

Sat, 12 April 2014 21:48

p.huber

Messages: 73
Registered: June 2012
Location: Oakland

Karma:

Member

Hi you all,

I checked my message I sent it was all scrabbled up! So I relisted it.

Just a reminder regarding the installation of the Torsion Bars. Each Torsion
Bar is stamped with an L and the other Torsion Bar is stamped with an R .

The torsion bars should be installed with the L and R going into the
porkchops. L stands for drivers side R for passenger side.

Don�t� forget to grease up the hex going into the lower A frame.

I came up with an easier way to have the height adjusted on the GMC. I use a
4X4 X 9 � inch long wood for the front end and a 4X4 X 8 1/8� inch long
wood for the rear end.

Adjust the rear first on a level spot, by putting the 4X4 X 8 1/8 inch wood
under to the frame. Once the rear end is adjusted properly do the same on
the front end.

However you have to put the 4X4 X 9 � inch long wood on the side of the
frame and then adjust the Torsion Bar by cranking up the porkchop. After
that drive around to settle the coach and re-check the heights in the rear
and front.

Minor adjustment might be necessary.

Happy GMCing

Peter D. Huber

GMC Royale 1978 403

_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Report message to a moderator

[Message index]

		[GMCnet] FW: Reminder Torsion Bar installation and other stuff. By: p.huber on Sat, 12 April 2014 21:48
		Re: [GMCnet] FW: Reminder Torsion Bar installation and other stuff. By: Ken Henderson on Sat, 12 April 2014 22:06
		Re: [GMCnet] FW: Reminder Torsion Bar installation and other stuff. By: xplorid on Fri, 25 April 2014 12:46
		Re: [GMCnet] FW: Reminder Torsion Bar installation and other stuff. By: SeanKidd on Fri, 25 April 2014 15:56
		Re: [GMCnet] FW: Reminder Torsion Bar installation and other stuff. By: USAussie on Fri, 25 April 2014 18:02
		Re: [GMCnet] FW: Reminder Torsion Bar installation and other stuff. By: SeanKidd on Fri, 25 April 2014 19:08

Previous Topic:	[GMCnet] items needed
Next Topic:	And so it begins. Spring is here, and with spring comes....

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Mar 19 16:21:20 CDT 2025

Total time taken to generate the page: 0.00594 seconds