Avion 50 amp wiring [message #242926] |
Mon, 10 March 2014 14:06 |
tphipps
Messages: 3005 Registered: August 2004 Location: Spanish Fort, AL
Karma:
|
Senior Member |
|
|
Finishing up the Honda install. Since the P.P.O. installed a u/i genset and did some re-wiring to the plug receptacle.
Question Ground lug needed to go to genset wiring?
Honda has following wires; Red, Red/White Stripe, White (2 separate wires)and Green.
Current receptacle wires; Black (2 separate wires) and White. Nothing connected to Ground lug.
1. Should I run a green wire to the ground lug on the receptacle from the genset?
2. The assumption is the Red and Red/White wires should connect to the black wires. These are the side lugs on the receptacle installed in the GMC.
3. Both White wires should be tired together and attached to the White wire. This is the bottom lug on the receptacle installed in the GMC.
There is 120v AC between the sets of Red and White. The Honda ev6010 can be wired to produce 240 AC.
Last step will be to figure out an exhaust system.
Tom, MS II
2012 Phoenix Cruiser model 2552
KA4CSG
|
|
|