Re: [GMCnet] Headliner FRP width [message #242921] |
Mon, 10 March 2014 11:48 |
rallymaster
Messages: 662 Registered: February 2004 Location: North Plains, ORYGUN
Karma: -4
|
Senior Member |
|
|
IIRC, Darrel, there are two cross beams, just aft of the front cap, that
are about 6-8 inches apart. I cut a piece to fit there, then trimmed the
next piece a little to fit the remaining large section. Coach not here,
so I can't measure.
Sure wish all the through-the-roof antenna, etc. holes were in that short
section.
RonC
On Mon, 10 Mar 2014 09:56:48 -0500 Darrel Folse <dfolse@aol.com> writes:
>
>
> Thanks all! I will measure and compare to the cardboard which
> seemed to be about 3/4 short on each side. Also, the front sheet
> needs to be about 50 3/4 front to back. I suppose I will need to
> splice in a piece to reach this dimension since the frp sheets are
> 48 inches, 2 3/4 short.
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
Ron & Linda Clark
1978 GMC Eleganza II
North Plains, ORYGUN
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Ron & Linda Clark
North Plains, ORYGUN
78 Eleganza II
|
|
|