Home » Public Forums » GMCnet » Fuel line routing
| Fuel line routing [message #239397] |
Mon, 10 February 2014 10:59  |
 |
SeanKidd
Messages: 747
Registered: June 2012
Location: Northern Neck Virginia
Karma: 4
|
Senior Member |
|
|
Other than to not cross the exhaust, Is there any reason to maintain the fuel line routing around the front of the engine to the mech fuel pump location, if you are installing electric pumps and removing the mechanical pump and blocking it off?
Sean and Stephanie
73 Ex-CanyonLands 26' #317 "Oliver"
Hubler 1-Ton, Quad-Bags, Rear Disc, Reaction Arms, P.Huber TBs, 3.70:1 LSD Honda 6500 inverter gen.
Colonial Travelers
|
|
|
|
| Re: [GMCnet] Fuel line routing [message #239422 is a reply to message #239397] |
Mon, 10 February 2014 13:51  |
emerystora
Messages: 4442
Registered: January 2004
Karma: 13
|
Senior Member |
|
|
No. Years ago I routed my all steel fuel line along the outside of the driver's side frame and moved the selector valve, a filter and an electric fuel pump outside the frame. My line goes up to the area of the brake combination valve and then on an angle up to the rear if the engine. It is connected to my TBi system with braided stainless steel over Teflon lines.
Emery Stora
> On Feb 10, 2014, at 9:59 AM, Sean Kidd <fiatkidd@yahoo.com> wrote:
>
>
>
> Other than to not cross the exhaust, Is there any reason to maintain the fuel line routing around the front of the engine to the mech fuel pump location, if you are installing electric pumps and removing the mechanical pump and blocking it off?
> --
> Sean and Stephanie
> 73 Ex-CanyonLands 26' #317 "Oliver"
> Hubler 1-Ton, Quad-Bags, Rear Disc, Reaction Arms,
> Fluorescent Mineral Capital of the World, New Jersey
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|
|
| Re: Fuel line routing [message #239492 is a reply to message #239397] |
Tue, 11 February 2014 01:04 |
Adrien G.
Messages: 474
Registered: May 2008
Location: Burns Flat, OK 73624
Karma: 1
|
Senior Member |
|
|
| SeanKidd wrote on Mon, 10 February 2014 10:59 |
Other than to not cross the exhaust, Is there any reason to maintain the fuel line routing around the front of the engine to the mech fuel pump location, if you are installing electric pumps and removing the mechanical pump and blocking it off?
|
Sean,
Due to possible vapor lock, I'd would think to keep the line located in the coolest and least vulnerable route. Which is what I think GM did.
JM2C
Adrien & Jenny Genesoto
75 Glenbrook (26-3) Mods LS3.70 FD / Reaction Sys / 80mm Front&Intermidiate / Hydroboost / 16" Tires / Frame Rebuild / Interior Rebuild
Yuba City,Ca. Text 530-nine-3-three-3-nine-nine-6
|
|
|
|
| Re: [GMCnet] Fuel line routing [message #239493 is a reply to message #239492] |
Tue, 11 February 2014 01:40 |
jimk
Messages: 6734
Registered: July 2006
Location: Belmont, CA
Karma: 9
|
Senior Member |
|
|
I preach to get the lines out to the outside of the frame and mount the
tank selector outside where the air in slow traffic an be much a 50
degrees cooler .
Some have had good results without doing this, but when you have covered
over almost 2 million miles under different conditions in the last 35 years
in these coaches, I have experienced various phenomena that some of you
have yet to face.
Be sure to replace the selector switch if not done in last 4 years
On Mon, Feb 10, 2014 at 11:04 PM, Adrien Genesoto <fixman54@syix.com> wrote:
>
>
> SeanKidd wrote on Mon, 10 February 2014 10:59
> > Other than to not cross the exhaust, Is there any reason to maintain
> the fuel line routing around the front of the engine to the mech fuel pump
> location, if you are installing electric pumps and removing the mechanical
> pump and blocking it off?
>
>
> Sean,
>
> Due to possible vapor lock, I'd would think to keep the line located in
> the coolest and least vulnerable route. Which is what I think GM did.
>
>
> JM2C
>
>
>
>
> --
> ”When we avoid the mistakes we might have made, we sometimes make
> the mistakes that we might have avoided.”
>
>
>
> Adrien & Jenny
> 75 Glenbrook
> Yuba City,Ca.
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
--
Jim Kanomata
Applied/GMC, Fremont,CA
jimk@appliedairfilters.com
http://www.appliedgmc.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502
|
|
|
|
| Re: [GMCnet] Fuel line routing [message #239496 is a reply to message #239493] |
Tue, 11 February 2014 02:40 |
Bruce Hart
Messages: 1501
Registered: October 2011
Location: La Grange, Wyoming
Karma: 5
|
Senior Member |
|
|
I recall Steve Ferguson had routed his stainless steel gas line between the
left valve cover and the intake manifold. It was raised above the intake
manifold by an inch or so. There was a photo of it but I can't bring up
any of his postings.
On Tue, Feb 11, 2014 at 12:40 AM, Jim Kanomata <jimkanomata@gmail.com>wrote:
> I preach to get the lines out to the outside of the frame and mount the
> tank selector outside where the air in slow traffic an be much a 50
> degrees cooler .
> Some have had good results without doing this, but when you have covered
> over almost 2 million miles under different conditions in the last 35 years
> in these coaches, I have experienced various phenomena that some of you
> have yet to face.
> Be sure to replace the selector switch if not done in last 4 years
>
>
> On Mon, Feb 10, 2014 at 11:04 PM, Adrien Genesoto <fixman54@syix.com>
> wrote:
>
> >
> >
> > SeanKidd wrote on Mon, 10 February 2014 10:59
> > > Other than to not cross the exhaust, Is there any reason to maintain
> > the fuel line routing around the front of the engine to the mech fuel
> pump
> > location, if you are installing electric pumps and removing the
> mechanical
> > pump and blocking it off?
> >
> >
> > Sean,
> >
> > Due to possible vapor lock, I'd would think to keep the line located in
> > the coolest and least vulnerable route. Which is what I think GM did.
> >
> >
> > JM2C
> >
> >
> >
> >
> > --
> > ”When we avoid the mistakes we might have made, we sometimes make
> > the mistakes that we might have avoided.”
> >
> >
> >
> > Adrien & Jenny
> > 75 Glenbrook
> > Yuba City,Ca.
> > _______________________________________________
> > GMCnet mailing list
> > Unsubscribe or Change List Options:
> > http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
> >
>
>
>
> --
> Jim Kanomata
> Applied/GMC, Fremont,CA
> jimk@appliedairfilters.com
> http://www.appliedgmc.com
> 1-800-752-7502
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
--
Bruce Hart
1976 Palm Beach
Milliken, Co
GMC=Got More Class
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Bruce Hart
1976 Palm Beach
1977 28' Kingsley
La Grange, Wyoming
|
|
|
|
| Re: [GMCnet] Fuel line routing [message #239497 is a reply to message #239496] |
Tue, 11 February 2014 03:37 |
Mr ERFisher
Messages: 7117
Registered: August 2005
Karma: 2
|
Senior Member |
|
|
On Tue, Feb 11, 2014 at 12:40 AM, Bruce Hart <hartsgmc@gmail.com> wrote:
> I recall Steve Ferguson had routed his stainless steel gas line between the
> left valve cover and the intake manifold. It was raised above the intake
> manifold by an inch or so. There was a photo of it but I can't bring up
> any of his postings.
>
you mean something like this?
http://gmcmotorhome.info/Fuel.html#filter
or this?
http://gmcmotorhome.info/howell.html#fuel
gene
>
>
> On Tue, Feb 11, 2014 at 12:40 AM, Jim Kanomata <jimkanomata@gmail.com
> >wrote:
>
> > I preach to get the lines out to the outside of the frame and mount the
> > tank selector outside where the air in slow traffic an be much a 50
> > degrees cooler .
> > Some have had good results without doing this, but when you have covered
> > over almost 2 million miles under different conditions in the last 35
> years
> > in these coaches, I have experienced various phenomena that some of you
> > have yet to face.
> > Be sure to replace the selector switch if not done in last 4 years
> >
> >
> > On Mon, Feb 10, 2014 at 11:04 PM, Adrien Genesoto <fixman54@syix.com>
> > wrote:
> >
> > >
> > >
> > > SeanKidd wrote on Mon, 10 February 2014 10:59
> > > > Other than to not cross the exhaust, Is there any reason to
> maintain
> > > the fuel line routing around the front of the engine to the mech fuel
> > pump
> > > location, if you are installing electric pumps and removing the
> > mechanical
> > > pump and blocking it off?
> > >
> > >
> > > Sean,
> > >
> > > Due to possible vapor lock, I'd would think to keep the line located in
> > > the coolest and least vulnerable route. Which is what I think GM did.
> > >
> > >
> > > JM2C
> > >
> > >
> > >
> > >
> > > --
> > > ”When we avoid the mistakes we might have made, we sometimes make
> > > the mistakes that we might have avoided.”
> > >
> > >
> > >
> > > Adrien & Jenny
> > > 75 Glenbrook
> > > Yuba City,Ca.
> > > _______________________________________________
> > > GMCnet mailing list
> > > Unsubscribe or Change List Options:
> > > http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
> > >
> >
> >
> >
> > --
> > Jim Kanomata
> > Applied/GMC, Fremont,CA
> > jimk@appliedairfilters.com
> > http://www.appliedgmc.com
> > 1-800-752-7502
> > _______________________________________________
> > GMCnet mailing list
> > Unsubscribe or Change List Options:
> > http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
> >
>
>
>
> --
> Bruce Hart
> 1976 Palm Beach
> Milliken, Co
> GMC=Got More Class
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
--
Gene Fisher -- 74-23,77PB/ore/ca
"Give a man a fish; you have fed him for today --- give him a URL and
-------
http://gmcmotorhome.info/
Alternator Protection Cable
http://gmcmotorhome.info/APC.html
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|
|
Goto Forum:
Current Time: Fri Nov 01 04:39:07 CDT 2024
Total time taken to generate the page: 0.13197 seconds
|
GMCforum
Search
Help
Register
Login
Home
