GMCforum: GMCnet » [GMCnet] OT: for aircraft folks

Home » Public Forums » GMCnet » [GMCnet] OT: for aircraft folks

Show: Today's Messages :: Polls :: Message Navigator

[GMCnet] OT: for aircraft folks [message #235048]

Sat, 04 January 2014 11:13

Gary Worobec

Messages: 867
Registered: May 2005

Karma:

Senior Member

I have a 5ft wooden two blade STANDARD propeller that I am restoring for a
decorative piece. The ends of the prop are gone probably 8 inches off each
end. I believe they had copper or brass on the leading edges of the tips.
What I need to know is what the metal usually was and whether it was
rabbeted into the wood or merely wrapped over the wood?. Also, were wood
screws used to fasten it ?

Thanks,

Gary Worobec

_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Report message to a moderator

[Message index]

		[GMCnet] OT: for aircraft folks By: Gary Worobec on Sat, 04 January 2014 11:13
		Re: [GMCnet] OT: for aircraft folks By: Gary Worobec on Sat, 04 January 2014 11:32
		Re: [GMCnet] OT: for aircraft folks By: Len Novak on Sat, 04 January 2014 11:47
		Re: [GMCnet] OT: for aircraft folks By: Len Novak on Sat, 04 January 2014 11:30
		Re: [GMCnet] OT: for aircraft folks By: Otterwan on Sat, 04 January 2014 12:10
		Re: [GMCnet] OT: for aircraft folks By: Gary Worobec on Sat, 04 January 2014 12:24
		Re: [GMCnet] OT: for aircraft folks By: emerystora on Sat, 04 January 2014 13:39
		Re: [GMCnet] OT: for aircraft folks By: Dennis S on Sat, 04 January 2014 13:00
		Re: [GMCnet] OT: for aircraft folks By: USAussie on Sat, 04 January 2014 14:37
		Re: [GMCnet] OT: for aircraft folks By: Otterwan on Sat, 04 January 2014 18:10
		Re: [GMCnet] OT: for aircraft folks By: Gary Worobec on Sat, 04 January 2014 20:34

Previous Topic:	Show me your back-up cam/monitor
Next Topic:	A shop pit - When was the first time you used one?

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Jan 15 10:59:30 CST 2025

Total time taken to generate the page: 0.00789 seconds