Re: [GMCnet] What have folks replaced their Onan 6.5 with? [message #223215 is a reply to message #223174] |
Fri, 20 September 2013 08:15 ![Go to previous message Go to previous message](/GMCforum/theme/default/images/up.png) ![Go to next message Go to previous message](/GMCforum/theme/default/images/down.png) |
Beach Coach
![Canada Canada](/GMCforum/images/flags/ca.png) Messages: 50 Registered: December 2011
Karma:
|
Member |
|
|
Another method to use for separating the end bell is as follows:
Remove the cover from your points and place a clean cloth over the points. This allows you room to place a small screw jack between the intake manifold and end bell. Apply some pressure to the jack and pry the corners of the end bell as it begins to separate; repeat this step using increasing pressure as needed until the end bell releases. Be careful not to apply too much pressure at once. JWID
hugh MacDougall
Antigonish, Nova Scotia
1975 Eleganza II
|
|
|