Tweaking door [message #222461] |
Sat, 14 September 2013 19:58 |
skip2
Messages: 544 Registered: September 2011 Location: Winter Haven,FL (center o...
Karma: 3
|
Senior Member |
|
|
Decided to tackle getting the arch on the door to match the body. Believe I've seen it posted before especially about removing window first. The service manual pretty generic on window removal, any words of wisdom out there.
Thanks
Skip Hartline
74 Canyon Lands, FiTech,
3.7 FD LSD, Manny Tranny,
Springfield Distributor,
2001 Chevy Tracker Ragtop Towd
|
|
|
|
Re: Tweaking door [message #222486 is a reply to message #222466] |
Sun, 15 September 2013 00:52 |
roy1
Messages: 2126 Registered: July 2004 Location: Minden nevada
Karma: 6
|
Senior Member |
|
|
Matt Colie wrote on Sat, 14 September 2013 19:55 |
skip2 wrote on Sat, 14 September 2013 20:58 | Decided to tackle getting the arch on the door to match the body. Believe I've seen it posted before especially about removing window first. The service manual pretty generic on window removal, any words of wisdom out there.
Thanks
Skip Hartline
|
Skip,
Quick answer is it takes:
A long 2x4,
A pair of hooks that you can make and
A jack - most people use a little hydraulic - I used a scissor
Search both GMCMI and GMCES archives and you should find the write-ups.
Good Luck.
Matt
| . Be very careful when I tried it my lower door hinge bolts were damaging the aluminum door. I wound up elongating the hinge holes in the door and sliding the door in a little.
Roy Keen
Minden,NV
76 X Glenbrook
|
|
|