GMCforum: GMCnet » [GMCnet] Replacing the engine dip stick tub

Home » Public Forums » GMCnet » [GMCnet] Replacing the engine dip stick tub

Show: Today's Messages :: Polls :: Message Navigator

[GMCnet] Replacing the engine dip stick tub [message #217619]

Sat, 10 August 2013 00:46

BobDunahugh

Messages: 2465
Registered: October 2010
Location: Cedar Rapids, IA

Karma:

Senior Member

It's rusted, and has a thin place just above the exhaust manifold. I'm thinking of cutting it off at that point. Then put a bolt down inside the tub. Then put locking pliers ( Vice Grips ) on the outside of the tube. The bolt will stop the tub from being crushed flat. Then pull the tub out. Will that work on a 78 403 ? I've done this on Chevy V8's before. Bob Dunahugh
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Report message to a moderator

[Message index]

		[GMCnet] Replacing the engine dip stick tub By: BobDunahugh on Sat, 10 August 2013 00:46
		Re: [GMCnet] Replacing the engine dip stick tub By: Galen on Sat, 10 August 2013 08:32
		[GMCnet] FW: Replacing the engine dip stick tub By: BobDunahugh on Sat, 10 August 2013 10:19
		Re: [GMCnet] FW: Replacing the engine dip stick tub By: Galen on Sat, 10 August 2013 12:18

Previous Topic:	looking for happy stories
Next Topic:	Re: [GMCnet] Can I hook speedo cable direct to the tranny instead of going through the box on the cr

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Oct 09 12:17:24 CDT 2024

Total time taken to generate the page: 0.02081 seconds