Home » Public Forums » GMCnet » Onan repair
Onan repair [message #216908] |
Sun, 04 August 2013 17:01 |
stick miller
Messages: 1036 Registered: March 2010 Location: Americus, Georgia
Karma:
|
Senior Member |
|
|
lqqkatjon wrote on Thu, 18 July 2013 08:44
When I first got my onan running. it seemed ok. then I tried to use it to run the roof air on a trip, and it turned into a leaker.
the little bit harder part was getting the old flywheel seal off.
I replaced at that time, the oil filter adaptor gaskets, and the flywheel seal.
it has been not leaking since that repair at this time.
Jon - I'm in a similar position. I have the flywheel removed as well as the oil filter adapter and along with the adapter (I assume) the LOP sensor.
Did you make your adapter gaskets? One (the front one nearest the filter) seems OK if not a bit puffy. The other one has a tear in it that could have happened when I took the thing apart. Both look like fairly simple gaskets. Were you able to source them anywhere.
Also, talk about the flywheel seal. That may be above my pay grade. How is the seal removed - replaced?
Thanks for any help you can give me. I want to reassemble this thing before I forget what goes where.
Stick Miller
'78 Royale - she left me for another man
'76 Eleganza
Americus, Georgia
Stick Miller
'78 Royale - "White Trash" - she left me for another man
'76 Eleganza - "Cousin Eddie" Sold '84 Bluebird Wanderlodge - "Past Tents"
Americus, GA
|
|
|
Goto Forum:
Current Time: Sun Sep 29 10:37:12 CDT 2024
Total time taken to generate the page: 0.01986 seconds
|