Onan Starter Solenoid [message #213348] |
Fri, 05 July 2013 11:51 |
DrPepper
Messages: 80 Registered: February 2013 Location: Goose Creek,SC
Karma:
|
Member |
|
|
I have a intresting porblem while I am on vacation inf Fla. First real time out in the GMC, and just loving it.
My Genset does engage pin 9 with 12V+ when i press the starter switch. I know the board is ok, because I can put it on another genset and it works. So after alot of reading on gmcws.org/Tech/dsimmons/onan/onan.html I have a question.
When I press the start switch I don't have any voltage on Pin 10. I traced the wire to the right Bolt(Small). I tested for power there when the starter is running and have 0v.
Is that right?
I read the Doc, Pin 10 need 12v+ from the Solenoid to engerize ping 9. right?
PS: Anyone know if I can pick up a replacment Solenoid at Auto-Zone?
Phillip Udel - I Own a 1975 Avion
|
|
|