GMCforum: GMCnet » Onan 6kw debugging, was replacing Onan

Home » Public Forums » GMCnet » Onan 6kw debugging, was replacing Onan

Show: Today's Messages :: Polls :: Message Navigator

Onan 6kw debugging, was replacing Onan [message #212740]

Sat, 29 June 2013 13:20

Mike Teets

Messages: 299
Registered: January 2004
Location: Dublin, OH

Karma:

Senior Member

Previous symptom was that it produced 70 volts instead of 120. Replaced the bridge rectifier. Same symptom. Left the geni running for a bit checking effect of engine speed on voltage. Then the voltage dropped to zero... or actually 0.5 volts. Removed the rectifier and tested with multimeter with diode tester. Still good.

Page 40 of the maintenance manual says I should see 38 ohms between F1 and F2... I see 0. Does this mean a short inside the windings or is that test only valid with the armature removed?

Time for yard work so stopped messing for now.

Mike
Dublin, OH

Mike, GMCing since 2002
77 Palm Beach, 260, 403
Dublin, OH
http://teamteets.com/gmc/

Report message to a moderator

[Message index]

		Onan 6kw debugging, was replacing Onan By: Mike Teets on Sat, 29 June 2013 13:20
		Re: [GMCnet] Onan 6kw debugging, was replacing Onan By: Jim Miller on Sat, 29 June 2013 13:39
		Re: [GMCnet] Onan 6kw debugging, was replacing Onan By: Mike Teets on Sat, 29 June 2013 13:53
		Re: [GMCnet] Onan 6kw debugging, was replacing Onan By: Jim Miller on Sat, 29 June 2013 14:03
		Re: [GMCnet] Onan 6kw debugging, was replacing Onan By: Mike Teets on Sat, 29 June 2013 14:20
		Re: [GMCnet] Onan 6kw debugging, was replacing Onan By: Mike Teets on Sat, 29 June 2013 19:00

Previous Topic:	Re: [GMCnet] Front wheel bearing re-pack
Next Topic:	Re: [GMCnet] Subject: Buzz Box Replacement Ground wire

Goto Forum:

-=] Back to Top [=-

Current Time: Sun Oct 06 09:25:26 CDT 2024

Total time taken to generate the page: 0.00651 seconds