[GMCnet] Attn. Anthony Ezzo - Eldo with the 4 piston calipers [message #212313] |
Wed, 26 June 2013 09:55 |
|
USAussie
Messages: 15912 Registered: July 2007 Location: Sydney, Australia
Karma:
|
Senior Member |
|
|
Anthony,
I created this new message as I and probably other would be interested in 4 piston calipers for our GMC's.
Where did you get four piston calipers for your Eldo?
How do they attach to the front knuckles?
Regards,
Rob
-----Original Message-----
From: anthony ezzo
I recently had a no brake situation, it was the cover leaking fluid out everytime the brakes were applied so after about 10 stops
the pedal went "Away".It also seen a bit of water. New lid, new fliud a few pumps on the pedal and been good ever since.
All my rubber lines are relatively new but on my Eldo with the 4 piston calipers, when the rubber goes, it locks those babys right
up. The only way to move the car is to either cut the line or open the bleader and try to push all pistons back equally. Its almost
impossible. So change the rubber lines!
--
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Regards,
Rob M. (USAussie)
The Pedantic Mechanic
Sydney, Australia
'75 Avion - AUS - The Blue Streak TZE365V100428
'75 Avion - USA - Double Trouble TZE365V100426
|
|
|