[GMCnet] Bogie Pin oddity... [message #204698] |
Sun, 14 April 2013 21:46 |
kelvin
Messages: 608 Registered: February 2004 Location: Eugene, OR
Karma:
|
Senior Member |
|
|
Cleaning bogie box, arms and pins todayI found an interesting thing.
Careful to keep all the pieces with their mating parts I suddenly found
myself with an extra pancake bearing... the flat bearing that goes on
each end of thearm where the pin goes thru. (between arm and bogie box
on both ends)
One of them had TWO pancake bearings on the back end of the arm.
Anyone seen this before? I measured stuff and it sure looks like it
needs to be there to take up space. My guess is the bogie box was
slightly miscast...
Just curious.
Kelvin
'73 23' in Eugene, OR
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|