| control arm bushings [message #203688] |
Fri, 05 April 2013 06:25  |
skip2
Messages: 544
Registered: September 2011
Location: Winter Haven,FL (center o...
Karma:
|
Senior Member |
|
|
After 1250 miles of white knuckle driving and praying for every pedestrian and bicycle I passed on the way to and from Dothan I am going to put on new lower control arm bushings, can see that the ones on it now are squished to one side. I remember someone posting about using a floor jack to support the lower arm popping with hammer to get it free from the ball joint verses using the pickle fork. Best I can tell the ball joint is not original, has bolts not rivets, and is ok. Just trying not to damage it or the seal. Any suggestions or comments.
Thanks
Skip Hartline
74 Canyon Lands, FiTech,
3.7 FD LSD, Manny Tranny,
Springfield Distributor,
2001 Chevy Tracker Ragtop Towd
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
