[GMCnet] Gas Tank Filler Tube [message #188729] |
Tue, 30 October 2012 10:04 |
Ron Morrison
Messages: 13 Registered: August 2009 Location: Chicago area
Karma: 0
|
Junior Member |
|
|
I have a 1974 coach, the gas tank filler tube is leaking at the rear of the elbow that enters the frame and crossmember below the filler pipe. I have replaced this 3 -4 inch piece of tubing twice and it still leaks even after double clamping it. I guess after 40 years the metal may have a pin hole leak.
In the parts book on page 12-2 & 12-3 Part #26 lists a first design which I probably have and a second design. The drawings are an artists dream and do not reflect what was built.
What does the second design look like?
If it looks better maybe I would like to replace my filler tubes with the second design, if I can find one.
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|
|
Re: [GMCnet] Gas Tank Filler Tube [message #188735 is a reply to message #188729] |
Tue, 30 October 2012 10:33 |
George Beckman
Messages: 1085 Registered: October 2008 Location: Colfax, CA
Karma: 11
|
Senior Member |
|
|
Ron Morrison wrote on Tue, 30 October 2012 08:04 | I have a 1974 coach, the gas tank filler tube is leaking at the rear of the elbow that enters the frame and crossmember below the filler pipe.
What does the second design look like?
If it looks better maybe I would like to replace my filler tubes with the second design, if I can find
|
I have had a 78 and now have a 74. I have no idea wether the 74 is a new or old design. Howeve,being in California, I can say that filling the 78 was a lesson in frustration. I had to make a gizmo to put over the filler tube because the pump nozzle would not go in the fillerfar at all. I had both coaches for two years. The 74 fills like a dream. The nozzle goes all the way in with ease. I measured every which way and could not figure out the difference except it appeared that the 74 came up at a alightly different angle. It "leans out" just a tad, so the nozzle headb is away from the top of the filler box.
So, there is a unscientific analysis. If I have the early, I don't want to change.
Are you sure the gas is not running down firm the vent hose? Mine are banded together.
'74 Eleganza, SE, Howell + EBL
Best Wishes,
George
|
|
|