Uploaded video of slack in front end [message #183189] |
Wed, 05 September 2012 12:40 |
|
RF_Burns
Messages: 2277 Registered: June 2008 Location: S. Ontario, Canada
Karma:
|
Senior Member |
|
|
Here is a video I took of the front end slack I was battling.
Everything was new on the front end except the bearings at this point.
The idler and relay arm were new (ok about 3000 miles) when I took this. Most of this was caused by the new "Built to OEM specs" idler arm and relay arm rocking on their pivot points.
I replaced them with Dave Lenzi rebuilts and lowered the front end so that the axle and tie rod ends were level, then most of this disappeared, although I can still move the wheels about 1/4".
http://youtu.be/bLiySgnK1uw
Bruce Hislop
ON Canada
77PB, 455 Dick P. rebuilt, DynamicEFI EBL EFI & ESC. 1 ton front end
http://www.gmcmhphotos.com/photos/showphoto.php?photo=29001
My Staff says I never listen to them, or something like that
|
|
|