GMCforum: GMCnet » What causes "chipmunk cheeks" again?

Home » Public Forums » GMCnet » What causes "chipmunk cheeks" again?

Show: Today's Messages :: Polls :: Message Navigator

What causes "chipmunk cheeks" again? [message #175453]

Tue, 03 July 2012 19:30

LarryInSanDiego

Messages: 336
Registered: September 2006

Karma:

Senior Member

I couldn't find the thread that talked about that. It's quite noticeable on my '73 as I'm getting ready to install a 2" wide 1/8" thick aluminum plate. Someone mentioned screwing through to some inner boards. I noticed that the part of the fender above the front wheelwell flares outward a bit when I push inward on the beltline. Hoe do I go about to remedy this?

Thanks in advance.

Larry Engelbrecht San Diego, CA '73 26' ex-Glacier TZE063V100319 03/07/73

Report message to a moderator

[Message index]

		What causes "chipmunk cheeks" again? By: LarryInSanDiego on Tue, 03 July 2012 19:30
		Re: What causes "chipmunk cheeks" again? By: Dennis S on Tue, 03 July 2012 20:12
		Re: [GMCnet] What causes "chipmunk cheeks" again? By: Ken Henderson on Tue, 03 July 2012 20:30
		Re: [GMCnet] What causes "chipmunk cheeks" again? By: Mr ERFisher on Wed, 04 July 2012 05:10
		Re: [GMCnet] What causes "chipmunk cheeks" again? By: Ken Henderson on Wed, 04 July 2012 05:59
		Re: [GMCnet] What causes "chipmunk cheeks" again? By: Dennis S on Wed, 04 July 2012 06:29
		Re: [GMCnet] What causes "chipmunk cheeks" again? By: Mr ERFisher on Wed, 04 July 2012 06:33
		Re: [GMCnet] What causes "chipmunk cheeks" again? By: Ray Erspamer on Wed, 04 July 2012 08:17

Previous Topic:	[GMCnet] Cyl head crack repair
Next Topic:	[GMCnet] Engine operating temperatures

Goto Forum:

-=] Back to Top [=-

Current Time: Thu Oct 10 23:28:56 CDT 2024

Total time taken to generate the page: 0.00565 seconds