| Installing steel fuel lines questions [message #170703] |
Thu, 24 May 2012 07:30  |
 |
Matt Colie
Messages: 8547
Registered: March 2007
Location: S.E. Michigan
Karma:
|
Senior Member |
|
|
Well, It seems this will be my year under the coach.... In a day or so, I will have the tanks defueled and down.
I want to put steel everywhere I can. Emery has suggested using brass compression fitting at the sending units.
Problem: Aren't there rolled barbs there to keep hoses on?
What does one do about those? I kind of hate to saw them off. I will if that is the good answer. I am not sure if I would rather that than use stubs of 30R9 to make the joint.
It is obvious that I will have to use 30R9 for parts of the system, I would just like to have those parts accessible for repairs that will be required later.
I am going to run double fill vents as far up as I can.
Matt
Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
