| TurboKool Update [message #165873] |
Mon, 09 April 2012 22:26 |
RadioActiveGMC
Messages: 1020
Registered: November 2010
Location: Hot AZ desert
Karma: 0
|
Senior Member |
|
|
First day I fired up my entire water system since I installed the turbokool and EZ101 water heater and plumbed it. It was only a practice run. I DIDN'T adjust the float so first time the pan over filled. When its over filled it doesn't cool as well as it should. I shut the pump off and as the water level slowly went down it worked better and better. It was over 90 today and the turbokool worked well.
However the float assy STINKS! When you tighten the water line up it makes the float valve twist. This is a pain in the butt cause its a pain to adjust the float to the correct water height. The value is poorly built, hard to adjust, and then when you get it right as soon as you install the water line and tighten it it makes the float change position. WHAT A PAIN IN THE BUTT.
However its able to be solved. I going to buy another nut for the valve so it doesn't spin as I tighten the water line. I'll use a dap of silicone on the float arm so when its in place it will stay in place. But my one big phat complaint is the entire valve assembly STINKS!
But it did blow really nice cold air 
***"Gettin There"-1973 23' Sequoia-
Michael, Onans smell, "Go solar/wind power!"
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
