Re: [GMCnet] Water Heater Questions [message #163833 is a reply to message #163827] |
Thu, 22 March 2012 09:27 |
Ken Henderson
Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma:
|
Senior Member |
|
|
Sorry, not link for aluminum mesh. Almost any general metal fabricator
might have scraps laying around. It's just "Expanded Aluminum". I had it
from a 4'x8' sheet I bought at a wholesaler to make radiator rock guards.
I'm not a fiberglass expert, so where I covered things, I just mixed up the
resin, poured it on, spread it around with a plastic Bondo spreader, then
laid in fiberglass cloth and saturated it with more resin where necessary.
A couple of outside compartments done that way 13 years ago have stood up
perfectly.
Ken H.
On Thu, Mar 22, 2012 at 9:28 AM, Bryan Hayes wrote:
>
>
> Ken, do you have a link to the aluminum mesh? And how would you go about
> fiberglassing the floor?
>
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|