Alignment question [message #163028] |
Thu, 15 March 2012 00:59 |
Ken Burton
Messages: 10030 Registered: January 2004 Location: Hebron, Indiana
Karma:
|
Senior Member |
|
|
Late last fall I replaced the upper rear a-frame bushings with off set ones. I cranked them all the way in and then set the camber to 0 on both sides. I then check the caster on both sides and they were equal so I left it that way.
I finally took the GMC out of winter hibernation in my hanger and took it for a ride for the first time since I put the bushings in. I have a slight pull to the right. Not much but enough to be irritating.
I am assuming that I need to add a bit of camber to the right side to correct this. I'm thinking about 1/2 degree but my question is which way.
I am assuming that the top a-frame needs to com out a bit.
Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana
|
|
|