Making A GMC Level In "Travel" Mode [message #159427] |
Sun, 05 February 2012 19:09  |
A Hamilto
 Messages: 4508 Registered: April 2011
Karma:
|
Senior Member |
|
|
If the body pads in the rear were about 1-7/16" thicker than the ones at the front, and the ones in between ranged in thickness to make the floor flat, wouldn't that make the vehicle look level going down the road when the ride height is set to spec?
Has anyone ever definitively established why the front is supposed to be higher than the rear?
If only because of caster, this should preserve it.
If it has something to do with ariflow to cool the engine or something, then this might mess it up.
And before someone else brings it up, I know it would require work on the plumbing.
|
|
|