Header / exhaust. Installation [message #156541] |
Thu, 12 January 2012 22:10 |
|
John Heslinga
Messages: 632 Registered: February 2011 Location: Edmonton, Alberta, Canada
Karma:
|
Senior Member |
|
|
Hi All:
I am currently installing a new 3inch exhaust and headers from Jim K. I've seen posts of people who melt the inner fenders. The only solution I remember suggested was to throw away the inner fenders. That is not a choice I would like to make. Canadian roads have too much dirt that kicks onto the engine. Is the melting common to most of your installations? What kinds of pre-emptive Solutions have you used or did you just not have that big a problem. What other elegant heat protection strategies have you used for speed cable?
John and Cathie Heslinga
1974 Canyonlands 260
455, Manny tranny and 1 ton, 3:70 LS,
Red Seal Journeyman, DTE, BEd. MEd.
Edmonton, Alberta
|
|
|