| Re: [GMCnet] Looking for Rivet nuts for led marker lights. [message #152738] |
Mon, 12 December 2011 19:58  |
sgltrac
Messages: 2797
Registered: April 2011
Karma: 1
|
Senior Member |
|
|
I found the exact replacement which I ordered from Tacoma screw. I have left the shop for the day but I will get u part # tomorrow. I would also buy stainless screws and put some anti-sieze on them. The factory well nuts are hard to seal. I would pull the caps and seal from the inside after assembly like the oe install especially since you can get the harness at the same time. IIRC it was Mr fisher who commented about replacement rubber expanding well nuts and that it did not work out for him.
Sully
77 royale
------Original Message------
From: steve & debbie
Sender: gmclist-bounces@temp.gmcnet.org
To: gmclist@temp.gmcnet.org
ReplyTo: gmclist@temp.gmcnet.org
Subject: [GMCnet] Looking for Rivet nuts for led marker lights.
Sent: Dec 12, 2011 5:10 PM
Hello,
i am having a big problem trying to get the correct Rivet nuts with the correct dimentions for the marker lights on the roof.
Please if anyone has some spare for this application i would gladly buy them from you. Enough for all the lights.
I did buy 100 with the correct screw thread size but they are too loose in the holes.
cheers and beers
--
Steve & Debbie
Monticello, FL
77 Palm Beach
EX G4WDT
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Sent from my Verizon Wireless BlackBerry
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Sully
77 Royale basket case.
Future motorhome land speed record holder(bucket list)
Seattle, Wa.
|
|
|
|
| Re: [GMCnet] Looking for Rivet nuts for led marker lights. [message #152748 is a reply to message #152738] |
Mon, 12 December 2011 21:09  |
glacierfl
Messages: 444
Registered: June 2011
Karma: 0
|
Senior Member |
|
|
hello Sully,
I have a set of stainless steel screws complete with o-rings ready to go.
It is a good idea using stainless, as it cuts down on later problems.
Cool, then i can order some and get those lights installed.
Then another "job jobbed", as we Brits like to say ....
cheers and beers
Steve & Debbie
Monticello, FL
77 Palm Beach :- Aurora
EX G4WDT
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
