GMCforum: GMCnet » Trouble

Home » Public Forums » GMCnet » Trouble (455 Blown Head Gaskets)

Show: Today's Messages :: Polls :: Message Navigator

Trouble [message #145486]

Tue, 04 October 2011 14:48

ggroth

Messages: 282
Registered: February 2004
Location: Carson City NV

Karma:

Senior Member

I have an engine problem; low compression in 1-3; 6-8. I pulled the heads and there is a very slight depression between those cylinders and that is where the head gasket blew out. I had the heads done in a San Diego head shop (recommended by Steve Ferguson) several years ago and have only put on less than 3K miles. Engine has not overheated and valves look good. My plan is to take the heads to a good shop in Reno NV and have them machined to a good flat shape again. Any suggestions that would be beneficial would be appreciated.

geo groth '73 260 Sequoia Carson City Nevada 89703

Report message to a moderator

[Message index]

		Trouble By: ggroth on Tue, 04 October 2011 14:48
		Re: Trouble By: Matt Colie on Tue, 04 October 2011 20:58
		Re: Trouble By: ggroth on Tue, 04 October 2011 22:56
		Re: [GMCnet] Trouble By: Wayne Newland on Tue, 04 October 2011 23:20

Previous Topic:	[GMCnet] old stinky fuel tanks
Next Topic:	Alcoa on eBay...Dodge 8 hole, plus others

Goto Forum:

-=] Back to Top [=-

Current Time: Sat Nov 16 01:52:32 CST 2024

Total time taken to generate the page: 0.00926 seconds