| Re: [GMCnet] tool question [message #143795] |
Mon, 19 September 2011 04:05 |
Richard Brown
Messages: 281
Registered: May 2009
Karma: 1
|
Senior Member |
|
|
This may not exactly be the best way, but it works. Get a breaker bar & an impact socket & slip a piece of pipe over it long enough to hit the frame. Leave some distance between the bar & the frame. Pull the coil wire & hook a remote starter switch to the starter. Bump the motor over & the leverage of the starter will break it loose. Only bump it until the bolt loosens off. You need the remote switch because you do NOT want to be under there when you do it & you sure don't want it to start. It's not as good as an impact, but it will get the job done.
Richard & Carol Brown
1974 Eleganza SE
"DILLIGAF"
Lindale, Tx. 75771
903-881-0192
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Richard & Carol Brown
1974 Eleganza SE
1174 Hickory Hills Dr.
Murchison, TX. 75778
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
