where does spacer go [message #142937] |
Sat, 10 September 2011 10:53 |
chasingsummer
Messages: 434 Registered: May 2011 Location: asheboro, nc
Karma:
|
Senior Member |
|
|
i have started my timing chain project, parts are not in so i figured i would get fan clutch and the air duct that surronds it off, so that i may access, fan and surrond are only this off, bets are not even loose yet
i know someone has been here on mine before because some bolts have washers and some dont.
during the process of removing the air shroud piece a spacer hit the floor. it is approx 5/8 wide and 3/8 thick. i can see that it could be used as a spacer if something needed this 3/8 offset for ?
it may not matter, but any thoughts where it may go?
thanks bgk
brian
asheboro, nc
75 eleganza, 74 build
119k miles and counting,
DOG HOUSE
|
|
|