| [GMCnet] sender measurements and electrical [message #127993] |
Mon, 30 May 2011 12:24  |
SergeL
Messages: 169
Registered: January 2011
Karma:
|
Senior Member |
|
|
Happy Memorial day ! And a special thanks to all of you out there that
have served our country.
(1) A few days back I asked this questions and so far there has been no
answers, so I will try again. I have looked up the drawings I could find
about where to cut the holes for the sender units on the floor but the
drawings don't say wether they are for the 23' or the 26' GMC. I have the 26
GMC, and do I have to even pull the tanks, it seams that if I use a router
and set the dept of cut, I should be able to do it without removing the
tanks.
(2) In order to remove all previous PO wiring much was small 24 gauge or
less with cracked insulation, I removed the dash and have spent many hours
since trying to get all gauges, lights and switches to work, they all worked
before I started this job but no longer function, I believe it is a ground
problem but so far have not come up with the solution. Any advice from some
of you that have completed this task? I am getting totally frustrated.
Thanks for any help
Serge
1973 GMC
Deming, NM
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
