|
|
Re: [GMCnet] Grease Zerks Jig [message #121283 is a reply to message #121249] |
Thu, 07 April 2011 22:10 |
emerystora
Messages: 4442 Registered: January 2004
Karma: 13
|
Senior Member |
|
|
You would only have to make the grooves about the width of your Dremel cutting wheel..
It would be less than 1/16" deep and 1/16" wide.
On Apr 7, 2011, at 5:12 PM, Don Hart wrote:
> Emery
>
> I miss spoke, as meant the spacer by going to deep with the grooves.
> How wide and deep. Reading the rest of the your response answers my
> question. Thanks
> Don
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
Emery Stora
77 Kingsley
Santa Fe, NM
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|