|
Re: [GMCnet] Grease Zerk Jig [message #121145 is a reply to message #121143] |
Wed, 06 April 2011 20:26 |
C Boyd
Messages: 2629 Registered: April 2006
Karma: 18
|
Senior Member |
|
|
Don Hart wrote on Wed, 06 April 2011 21:13 | Chuck B,
I have the bearing set #23, but need a set of seals. Can not seem to
find them around here. Is there a set depth and with to the spacer and how
about the drill bit size? Thanks
Don
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
Don: I been getting my seals from Jim K. The spacer comes with the set-23 bearings and has to be modified and kept with that set of bearings. I`ll check on the drill bit sizes we need and will let you know. Last set I drilled it took 6 drill bits to drill 8 holes.
C. Boyd
76 Crestmont
East Tennessee
|
|
|
|
|
Re: [GMCnet] Grease Zerk Jig [message #121152 is a reply to message #121150] |
Wed, 06 April 2011 20:51 |
C Boyd
Messages: 2629 Registered: April 2006
Karma: 18
|
Senior Member |
|
|
emerystora wrote on Wed, 06 April 2011 21:31 |
On Apr 6, 2011, at 7:26 PM, Charles Boyd wrote:
>
>
> Don Hart wrote on Wed, 06 April 2011 21:13
>> Chuck B,
>>
>> I have the bearing set #23, but need a set of seals. Can not seem to
>> find them around here. Is there a set depth and with to the spacer and how
>> about the drill bit size? Thanks
>>
>> Don
>> _______________________________________________
>
Rather than trying to drill holes through the spacer just take a Dremel tool and put a shallow groove all the way around the outer face of the spacer and then cut some cross slots across the outer surface of the spacer. The groove and slots will allow grease to flow as well as holes would.
Emery Stora
77 Kingsley
Santa Fe, NM
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
Yes Sir I have thought of that cause it is getting harder to borrow drill bits around here.
C. Boyd
76 Crestmont
East Tennessee
|
|
|