GMCforum: GMCnet » A Question For Dan G

Home » Public Forums » GMCnet » A Question For Dan G

Show: Today's Messages :: Polls :: Message Navigator

A Question For Dan G [message #116719]

Sat, 26 February 2011 21:29

JShot

Messages: 485
Registered: October 2006
Location: NW Ohio

Karma:

Senior Member

Dan,

On the new engine, did you install that sheet metal "tray" in the bottom of the valley that holds the lifters in (in case of a bent push rod) That Mondello sells?

John

John Shotwell
Ridgeville Corners, OH
78 Royale Center Kitchen

Report message to a moderator

[Message index]

		A Question For Dan G By: JShot on Sat, 26 February 2011 21:29
		Re: A Question For Dan G By: WD0AFQ on Sat, 26 February 2011 22:02
		Re: A Question For Dan G By: gmchunter on Sat, 26 February 2011 23:34
		Re: [GMCnet] A Question For Dan G By: USAussie on Sun, 27 February 2011 00:11
		Re: [GMCnet] A Question For Dan G By: WD0AFQ on Sun, 27 February 2011 09:52
		Re: [GMCnet] A Question For Dan G By: jimk on Sun, 27 February 2011 14:24
		Re: A Question For Dan G By: GMCNUSA on Sun, 27 February 2011 16:44
		Re: A Question For Dan G By: WD0AFQ on Sun, 27 February 2011 17:23
		Re: A Question For Dan G By: GMCNUSA on Sun, 27 February 2011 17:27
		Re: [GMCnet] A Question For Dan G By: Douglas Norton on Sun, 27 February 2011 17:40
		Re: [GMCnet] A Question For Dan G By: USAussie on Sun, 27 February 2011 20:34
		Re: A Question For Dan G By: RF_Burns on Sun, 27 February 2011 10:12
		Re: A Question For Dan G By: WD0AFQ on Sun, 27 February 2011 10:51
		Re: [GMCnet] A Question For Dan G By: USAussie on Sun, 27 February 2011 13:56
		Re: [GMCnet] A Question For Dan G By: James Hupy on Sun, 27 February 2011 21:11
		Re: [GMCnet] A Question For Dan G By: gmcrv1 on Sun, 27 February 2011 21:41
		Re: [GMCnet] A Question For Dan G By: USAussie on Mon, 28 February 2011 00:19
		Re: [GMCnet] A Question For Dan G By: James Hupy on Mon, 28 February 2011 03:05
		Re: [GMCnet] A Question For Dan G By: gmcrv1 on Mon, 28 February 2011 09:26
		Re: [GMCnet] A Question For Dan G By: Ken Burton on Mon, 28 February 2011 04:17

Previous Topic:	Electric fuel pump question
Next Topic:	New member posting in swap meet

Goto Forum:

-=] Back to Top [=-

Current Time: Mon Nov 18 00:18:41 CST 2024

Total time taken to generate the page: 0.00921 seconds