| Hallway wire [message #115991] |
Mon, 21 February 2011 15:24  |
jtblank
Messages: 237
Registered: June 2007
Location: Tulare, CA
Karma:
|
Senior Member |
|
|
Well I started taking out the headliner and found this 12V wire dead-ending in back of hallway at the first joint, I was wondering what it's there for. Maybe for vent? I've got dual A/C units so vent not there. http://www.gmcmhphotos.com/photos/showphoto.php?photo=37818&title=12v-power-to-what-3f&cat=5587
Hope the rest goes as easily as the first panel, although had to jack the roof up slightly on the passenger side as it had the headliner wedged tight. That leads to the question of should I trim the top of the rear bath module wall to give clearance for putting the panels back, I don't think the roof will stay up once I remove the brace.
Also those wire covers that everyone says are a bear to remove are truly a PITA, after a couple minutes trying to get off without breaking I said screw-it and commenced to the old grab and rip.... ending in tons of pieces but didn't take long!
John Blankenship
'76 Palm Beach
Tulare, CA
[Updated on: Mon, 21 February 2011 15:26] Report message to a moderator |
|
|
|
GMCforum
Search
Help
Register
Login
Home
