| [GMCnet] Fw: The 403 has arrived [message #114343] |
Sat, 05 February 2011 21:23 |
jade
Messages: 163
Registered: August 2009
Karma: 0
|
Senior Member |
|
|
----- Original Message -----
From: "Jim Decheine" <jade@tabletoptelephone.com>
To: <gmclist@temp.gmcnet.org>
Sent: Saturday, February 05, 2011 8:16 PM
Subject: Re: [GMCnet] The 403 has arrived
> OK Paul.
> I'll use them when I take the old motor over to Steve's.
> Being originally from MN., I know all about the snow thing.
> We also have a place up on the mountains, (7,000 ft.) here in AZ
> and when we were up there a couple of weeks ago we had 18".
> I spent 6 1/2 hours blowing that wonderful stuff out.
> Thanks again for all the time you spent on getting that motor ready and
> shipping it.
> JADE
> 73 23' ?? 73 26' Palm Desert
> Ajo, AZ
> KC7QGC
>
>
> ----- Original Message -----
> From: "Paul Leavitt" <leavittpaul@yahoo.com>
> To: <gmclist@temp.gmcnet.org>
> Sent: Saturday, February 05, 2011 8:01 PM
> Subject: Re: [GMCnet] The 403 has arrived
>
>
>>
>>
>> No,,,please don't bother to send those tydowns back. I've got lots and
>> those are the thinner cheap ones. I was lucky enough to make it all out
>> of scrap. I thought it would help to tie the front and rear of the crank
>> to the pallet.I went to install the dist. and found it was too tall. Or
>> the top was too low. We recieved 12-13 inches of snow and last night just
>> got 2 inches more. I wish the bad weather hadn't held me up and let me
>> ship it sooner. Oh,,, more snow predicted for sunday night and tuesday
>> night. Am going to work on raking it off the roof tomorrow!!! Some fun.
>> Good luck on the install,,,,,PL
>> _______________________________________________
>> GMCnet mailing list
>> Unsubscribe or Change List Options:
>> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>>
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
