[GMCnet] The 403 has arrived [message #114096] |
Thu, 03 February 2011 19:40 |
jade
Messages: 163 Registered: August 2009
Karma: 0
|
Senior Member |
|
|
Paul did a fantastic job crating the 403 for it's journey from Mo. to AZ.
Picked it up at the dock this afternoon and uncrated it.
The freight company was UPS Freight, $ 252.00
That crate made it here in better shape than most packages I send UPS and
I retired from there 20 years ago, some things never change.
Going to put seals, gaskets and block off plates in before the install.
Got started this morning removing the bad motor from Frazier's coach.
Will keep you posted on progress.
A great big THANKS again Paul.
We will send your tie downs back to you.
JADE
73 23' ?? 73 26' Palm Desert
Ajo, AZ
KC7QGC
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|
|
|
|
|
|
Re: [GMCnet] The 403 has arrived [message #114339 is a reply to message #114096] |
Sat, 05 February 2011 21:01 |
g.winger
Messages: 792 Registered: February 2008 Location: Warrenton,Missouri
Karma: 0
|
Senior Member |
|
|
No,,,please don't bother to send those tydowns back. I've got lots and those are the thinner cheap ones. I was lucky enough to make it all out of scrap. I thought it would help to tie the front and rear of the crank to the pallet.I went to install the dist. and found it was too tall. Or the top was too low. We recieved 12-13 inches of snow and last night just got 2 inches more. I wish the bad weather hadn't held me up and let me ship it sooner. Oh,,, more snow predicted for sunday night and tuesday night. Am going to work on raking it off the roof tomorrow!!! Some fun. Good luck on the install,,,,,PL
|
|
|
Re: [GMCnet] The 403 has arrived [message #114342 is a reply to message #114339] |
Sat, 05 February 2011 21:16 |
jade
Messages: 163 Registered: August 2009
Karma: 0
|
Senior Member |
|
|
OK Paul.
I'll use them when I take the old motor over to Steve's.
Being originally from MN., I know all about the snow thing.
We also have a place up on the mountains, (7,000 ft.) here in AZ
and when we were up there a couple of weeks ago we had 18".
I spent 6 1/2 hours blowing that wonderful stuff out.
Thanks again for all the time you spent on getting that motor ready and
shipping it.
JADE
73 23' ?? 73 26' Palm Desert
Ajo, AZ
KC7QGC
----- Original Message -----
From: "Paul Leavitt" <leavittpaul@yahoo.com>
To: <gmclist@temp.gmcnet.org>
Sent: Saturday, February 05, 2011 8:01 PM
Subject: Re: [GMCnet] The 403 has arrived
>
>
> No,,,please don't bother to send those tydowns back. I've got lots and
> those are the thinner cheap ones. I was lucky enough to make it all out of
> scrap. I thought it would help to tie the front and rear of the crank to
> the pallet.I went to install the dist. and found it was too tall. Or the
> top was too low. We recieved 12-13 inches of snow and last night just got
> 2 inches more. I wish the bad weather hadn't held me up and let me ship it
> sooner. Oh,,, more snow predicted for sunday night and tuesday night. Am
> going to work on raking it off the roof tomorrow!!! Some fun. Good luck on
> the install,,,,,PL
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|