| [GMCnet] Fw: Onan, again. [message #112146] |
Sun, 16 January 2011 12:57 |
George Zhookoff
Messages: 398
Registered: December 2004
Location: Snellville, GA
Karma:
|
Senior Member |
|
|
Here's a past email. HTH
----- Original Message -----
From: gmclist-bounces@temp.gmcnet.org <gmclist-bounces@temp.gmcnet.org>
To: gmclist@temp.gmcnet.org <gmclist@temp.gmcnet.org>
Sent: Sat Sep 04 11:46:13 2010
Subject: Re: [GMCnet] Onan, again.
George Zhookoff wrote on Sat, 04 September 2010 07:59
> Well here we sit at the Atlanta Nascar race. ... Been running the Onan most of the time ... she up and quit. ...
>
> Question is what is killing the board? ...
I do not know what is eating your boards. But AFTER you confirm the board is bad, AND everything else is good, you can get it running again....
Disclaimer: I would not run your Onan unattended with this work-a-round. This work-a-round by-passes the safety features of the board. It will NOT turn off power to the fuel pump and points if the motor stops for some reason other than the off switch. It also removes the low oil protections. Your results may vary and do not blame me! 8o
Find the lower pin 6. (It is normally not used.) Use a crimp on connector to jump it to the pin right next to it. (I am pretty sure it is pin 9.) The Onan should start and run normally. It should even stop when you press "off."
--
Mike Miller
`73 26' X Painted D.
`78 23' Birchaven
Hillsboro, OR
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
