GMCforum: GMCnet » [GMCnet] Furnace

Home » Public Forums » GMCnet » [GMCnet] Furnace

Show: Today's Messages :: Polls :: Message Navigator

[GMCnet] Furnace [message #108513]

Mon, 13 December 2010 19:55

john arbuckle

Messages: 122
Registered: March 2010

Karma: 0

Senior Member

Any ideas?

I just got a super deal on a suburban furnace SF-F 30 and am going to
install it in the same place the Sol Aire was. Has anyone successfully done
this or have any ideas to make this as easy as possible. Again thank you to
anyone with any info on this subject. Pictures are with a thousand words if
possible.
Thank you
John Arbuckle
1976 Palm Beach
Tucson AZ
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Report message to a moderator

Re: [GMCnet] Furnace [message #108517 is a reply to message #108513]

Mon, 13 December 2010 21:07

GeorgeRud

Messages: 1380
Registered: February 2007
Location: Chicago, IL

Karma: 0

Senior Member

There are some pictures that should help you on the photo site. Look under interior modifications - it's posted on the first page by dennis lecomte (sp?).

George Rudawsky
Chicago, IL
75 Palm Beach

Report message to a moderator

Re: [GMCnet] Furnace [message #108527 is a reply to message #108513]

Mon, 13 December 2010 23:07

Mr ERFisher

Messages: 7117
Registered: August 2005

Karma: 2

Senior Member

how about this on SF

http://gmcmotorhome.info/heat.html#solaire

gene

On Mon, Dec 13, 2010 at 5:55 PM, john arbuckle <jarbuckle1209@gmail.com>wrote:

> Any ideas?
>
> I just got a super deal on a suburban furnace SF-F 30 and am going to
> install it in the same place the Sol Aire was. Has anyone successfully done
> this or have any ideas to make this as easy as possible. Again thank you to
> anyone with any info on this subject. Pictures are with a thousand words if
> possible.
> Thank you
> John Arbuckle
> 1976 Palm Beach
> Tucson AZ
> _______________________________________________
> GMCnet mailing list
> List Information and Subscription Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
>

--
Gene Fisher -- 74-23,77PB/ore/ca
�Give a man a fish; you have fed him for today --- give him a URL and
-------
http://gmcmotorhome.info/
Alternator Protection Cable
http://gmcmotorhome.info/APC.html
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Report message to a moderator

Re: [GMCnet] Furnace [message #108530 is a reply to message #108513]

Mon, 13 December 2010 23:23

Erv Troyer

Messages: 125
Registered: February 2004
Location: Lagrange, IN

Karma: 0

Senior Member

john arbuckle wrote on Mon, 13 December 2010 19:55

Yep - Denis Leconte did that very thing, and posted lotsa pictures:
http://www.gmcmhphotos.com/photos/showgallery.php?cat=5082

Probably more than you wanted to know, but it is definitely do-able.
Erv Troyer
Lagrange, IN

Report message to a moderator

Re: [GMCnet] Furnace [message #108534 is a reply to message #108530]

Mon, 13 December 2010 23:44

WD0AFQ

Messages: 7111
Registered: November 2004
Location: Dexter, Mo.

Karma: 207

Senior Member

Boy, Denis sure did a great job. I installed one of those a couple of years back. We just ripped the entire kitchen out and that made it easier. After installing the new SF we built the kitchen around it. I had to remove it last year to test it but no big deal. Found the problem was one of the thermostat wires was broken inside the ceiling. You can do it if I can. Bring that bad boy to Quartzsite and Ken B, Carl S, and I will get it in there for you. Very Happy

Dan

3 In Stainless Exhaust Headers One Ton All Discs/Reaction Arm 355 FD/Quad Bag/Alum Radiator Manny Tran/New eng. Holley EFI/10 Tire Air Monitoring System Solarized Coach/Upgraded Windows Satelite TV/On Demand Hot Water/3Way Refer

Report message to a moderator

Re: [GMCnet] Furnace [message #108535 is a reply to message #108513]

Tue, 14 December 2010 00:02

George Beckman

Messages: 1085
Registered: October 2008
Location: Colfax, CA

Karma: 11

Senior Member

john arbuckle wrote on Mon, 13 December 2010 17:55

John,

Are there any more where you got the good deal. Our furnace is on its last legs.

'74 Eleganza, SE, Howell + EBL
Best Wishes,
George

Report message to a moderator

Re: [GMCnet] Furnace [message #108636 is a reply to message #108535]

Wed, 15 December 2010 19:03

john arbuckle

Messages: 122
Registered: March 2010

Karma: 0

Senior Member

Sorry last one but I would keep tryin because they get new stuff all the
time, It was at Arizona RV salvage in PHX.

On Mon, Dec 13, 2010 at 10:02 PM, George Beckman <gbeckman@pggp.com> wrote:

>
>
> john arbuckle wrote on Mon, 13 December 2010 17:55
> > Any ideas?
> >
> > I just got a super deal on a suburban furnace SF-F 30 and am going to
> > install it in the same place the Sol Aire was. Has anyone successfully
> done
> > this or have any ideas to make this as easy as possible. Again thank you
> to
> > anyone with any info on this subject. Pictures are with a thousand words
> if
> > possible.
> > Thank you
> > John Arbuckle
> > 1976 Palm Beach
> > Tucson AZ
> > _______________________________________________
> > GMCnet mailing list
> > List Information and Subscription Options:
> > http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
> John,
>
> Are there any more where you got the good deal. Our furnace is on its last
> legs.
>
>
> --
> '74 Eleganza, SE, Howell + EBL
> Best Wishes,
> George
> _______________________________________________
> GMCnet mailing list
> List Information and Subscription Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Report message to a moderator

Re: [GMCnet] Furnace [message #108639 is a reply to message #108534]

Wed, 15 December 2010 19:24

john arbuckle

Messages: 122
Registered: March 2010

Karma: 0

Senior Member

Do you really have to add a plenum to the shell? Could you not just use the
vent collars on the stock unit and use a T in the vent along the galley
floor and run 4 inch flex vent to both registers. Then use the second 4 inch
collar facing the rear of the coach all the way to the back of the rig use a
T once again above the area where the water pump is stored and use a reducer
to run 2-2 1/2 off that T to the bathroom? Just a question not a great
metal worker so that would be easier. Thanks for any type of help you can
give.

John Arbuckle
1976 Palm beach
Tucson az

On Mon, Dec 13, 2010 at 9:44 PM, Dan Gregg <gregg_dan@hotmail.com> wrote:

>
>
> Boy, Denis sure did a great job. I installed one of those a couple of years
> back. We just ripped the entire kitchen out and that made it easier. After
> installing the new SF we built the kitchen around it. I had to remove it
> last year to test it but no big deal. Found the problem was one of the
> thermostat wires was broken inside the ceiling. You can do it if I can.
> Bring that bad boy to Quartzsite and Ken B, Carl S, and I will get it in
> there for you. :d
> Dan
> --
> Dan & Teri Gregg
>
> http://danandteri.blogspot.com/
>
>
>
>
> _______________________________________________
> GMCnet mailing list
> List Information and Subscription Options:
> http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist
>
_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Report message to a moderator

Re: [GMCnet] Furnace [message #108640 is a reply to message #108513]

Wed, 15 December 2010 19:28

RadioActiveGMC

Messages: 1020
Registered: November 2010
Location: Hot AZ desert

Karma: 0

Senior Member

I uninstalled my furnace and the reinstalled it. I noticed that your looks like mine however I have 4 vents otherwise they look the same.
It looks like my furnace had to be put on a small platform so the exhaust vents lined up.
I ran my 12v wires a little different. I kept the original ones that go across the coach, but I added #8 power wire and spliced it in direct at the furnance to the house battery so there is no voltage loss. A small run of #8 shows super low loss and my furnace lights up great now.

***"Gettin There"-1973 23' Sequoia- Michael, Onans smell, "Go solar/wind power!"

Report message to a moderator

Re: [GMCnet] Furnace [message #108642 is a reply to message #108639]

Wed, 15 December 2010 19:42

timdehaan

Messages: 26
Registered: October 2010

Karma: 0

Junior Member

No. Air is not like water where you can just tap into it and get apx the same pressure as you started with. We use inches of water column to measure air pressure in a duct as apposed to pounds per square inch to measure water pressure.

If you want to use one duct to go two places you should start with a 5" duct off the plenum and then use a wye, not a tee, to reduce both down to 4". Air is lazy and will not turn 90 degrees if it can go straight so a 4x4x4 tee does little good.

Tim, soon to be a GMC owner rather than a wanna be .

----- "john arbuckle" <jarbuckle1209@gmail.com> wrote:

Do you really have to add a plenum to the shell? Could you not just use the
vent collars on the stock unit and use a T . . .

_______________________________________________
GMCnet mailing list
List Information and Subscription Options:
http://temp.gmcnet.org/cgi-bin/mailman/listinfo/gmclist

Report message to a moderator

Re: [GMCnet] Furnace [message #108660 is a reply to message #108642]

Wed, 15 December 2010 22:19

WD0AFQ

Messages: 7111
Registered: November 2004
Location: Dexter, Mo.

Karma: 207

Senior Member

John, here is a link to my photo album, where we installed the furnace. It has been two years now so I can't say this will help you. Just take a look. You can see it in there without the kitchen counter.
http://www.gmcmhphotos.com/photos/showgallery.php?cat=4888
Dan in Duncan, Az.

Report message to a moderator

Previous Topic:	Cad 500 Help
Next Topic:	Attn Dave G.

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Nov 20 07:32:38 CST 2024

Total time taken to generate the page: 0.01870 seconds