Long version of a short story [message #106558] |
Tue, 23 November 2010 13:37 |
Gil Slaw
Messages: 69 Registered: May 2006 Location: Hampshire, IL
Karma:
|
Member |
|
|
I need to tap the collective wisdom of this group once again.
When I bought my coach I discovered a significant lateral crack on the floor of the intake manifold and I decided to replace the cast iron piece with an Edlebrock Performer.
After 5 years of tripping over 3 versions of the dog house I give up!
I found a perfect Toronado intake last week and I plan on installing it over the next few days and now my delema:
I have fabricated a pair of stainless plates from a ground down
kichen knife that would never stay sharp.
The question is should I drill, say 1/4 inch hole in each plate to give some early heat to the TBI, or should they remain blank??
Any thoughts?
Gil Slaw
|
|
|