No power [message #104620] |
Sat, 30 October 2010 11:34 |
Smitty52
Messages: 181 Registered: July 2007
Karma:
|
Senior Member |
|
|
OK, no start. Actually no power. Doing the EFI install and ready to fire it for the first time. I hooked the battery back up and there were no sparks to indicate a short or power draw. Had power for a while cause the door buzzer went off when I turned the key on. Turned the key to on and heard a whoosh which I took to be the fuel pump pushing fuel and the air heading to the return. Tried to connect the flash cable and
had to download a usb to serial software patch. Got that done and went to try it again and no power. The fuse box is dead - no power. Checked the battery - it lights a test lamp and I made sure the connections are clean and tight. The ground connection on the block is secure. Tried the boost switch and heard a thud but still no power.
I tied into the crank sensor at the top of the engine so I never was able to get at the connections on the starter. Miguel put a new starter in when he redid the motor. There is power to the starter solenoid.
Ideas?
Wayne and Lisa,
Bolton Landing, NY,
Patriot Guard Rider,
Standing for those who stood for us.
|
|
|